Main > Main Forum

New I-PAC Firmware

<< < (3/7) > >>

kronic24601:
That was my assumption, but I'll ask just to be sure

EDIT: Yes, that is correct. I have done the update. One thing to note, this will not work if you use the PS/2 connector, you will need the USB adapter or cable to do both the update or to utilize the features of the update.

DillonFoulds:
Hmmm... I've recently purchased my I-pac4 (ps2 version), so where does that leave me? Does a USB-PS2 interface work, or are the two totally different, then?

kronic24601:
1) So far as I'm aware, all the Units have a PS2 interface on the board itself. Andy sells a PS2-USB cable if you want the cable portion. If you want to use the this software update, you need to use USB in one form or another. I used a USB/PS2 Adapter that you can get pretty much anywhere and it seems to work fine. Apparently however there are "converters" which are different than an adapter, and these will have problems ... so you don't want a converter, you want an adapter. Problem is, most websites don't make any clear distinction between them, but I think most are adapters.

tsaylor:
Has anyone heard if this is relevant to the MiniPAC (or if an update is planned for that board too)?

GoingIncognito:
I hope the MiniPac gets a firmware update :)

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version