Main > Main Forum

U360 - Best way to tighten joystick?

<< < (4/4)

I/O:

--- Quote from: Franco B on June 29, 2010, 07:33:37 am ---Which is a more complex solution than just using a screw driver in this situation.

--- End quote ---

Only if you want to take off the PCB to get at the bottom of the shaft.

Franco B:
Yes, and guess which tool you use for that?

But meh. What works for you, works for you.

Ginsu Victim:

--- Quote from: I/O on July 01, 2010, 09:24:31 pm ---
--- Quote from: Franco B on June 29, 2010, 07:33:37 am ---Which is a more complex solution than just using a screw driver in this situation.

--- End quote ---

Only if you want to take off the PCB to get at the bottom of the shaft.

--- End quote ---

OH NO! Four plastics nuts I have to remove with my fingers!!! ::)

I/O:

--- Quote from: Ginsu Victim on July 03, 2010, 12:52:59 pm ---
--- Quote from: I/O on July 01, 2010, 09:24:31 pm ---
--- Quote from: Franco B on June 29, 2010, 07:33:37 am ---Which is a more complex solution than just using a screw driver in this situation.

--- End quote ---

Only if you want to take off the PCB to get at the bottom of the shaft.

--- End quote ---

OH NO! Four plastics nuts I have to remove with my fingers!!! ::)

--- End quote ---

I could be stuffing more fries in my mouth in the few mintues it takes to do this maneuver you suggest.

nickynooch:
I had the exact same problem, I emailed the ultimarc guys they responded to use plumbers tape.

Worked like a champ.  Haven't had a problem since.  It's a great cheap solution.

Just wrap it around the groove on the stick part where the top screws on.  (You'd probably just figure it out).  I highly recommend that method.

Navigation

[0] Message Index

[*] Previous page

Go to full version