Main > Main Forum

Replacing U360 shaft & spring

<< < (2/3) > >>

dawolv:
Try it this way:

nosecondcity:
Thanks for the pics.

 I just tried removing the shaft from the 2nd joystick and it came out no problem. So I think there might be a problem with one of the joysticks. I'm gonna try to tinker with it a bit.

Now that it's out like in the last picture, how do I actually get the shaft out? I'm still confused on this.

Thanks again for the help.

edge10:
EDIT --  There is now screw at the bottom of the shaft!  Please disregard this post. /EDIT

Any advice on replacing the springs?  I just tried removing the screw on the bottom of mine and I screwed up the finish on the shaft.  The screw still won't budge (thanks to whomever tightened it down).  These things aren't reverse threaded are they?

As always, thanks in advance,

Dave

I/O:
To change the spring on (I think) any stick, you have to compress it by pushing on the actuator, and then removing the C clip underneath. Make sure you do not let it fly.

Ginsu Victim:

--- Quote from: edge10 on July 22, 2010, 09:54:52 pm ---I just tried removing the screw on the bottom of mine and I screwed up the finish on the shaft. 

--- End quote ---

That's not a screw. It's for inserting a screwdriver while you tighten the ball or bat top.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version