Main > Main Forum

1xxx-in-1 Help Needed!! ( Can't boot to game screen)

(1/4) > >>

Larrabee:
I just got the board today.

Mounted the motherboard and power supply.

Hooked up the jamma wires, VGA connector, and power.

It boots but after a minute I have a blank screen.

here are some pictures and a video. Any ideas?




And here is a video of it:

Thank you!

BobA:
Can't see much in your video.   Did you go thru the setup of your board by switching bit 4 to setup from game then setup your video by pushing the button as per the manual.

Larrabee:
When I do that I get nothing on the screen. I will take a better video now.

Larrabee:
So to recap, I have:
1. Mounted the board to my cabinet
2. Connected my VGA cable from my monitor to the board
3. Connected the Jamma connector to board
4. Connected the ATX power Supply to the board
5. I then turned on the power for the Jamma
6. Turned on power to ATX Power supply

I saw the windows 200 boot up screen then nothing.

I tried turning on switch 4 to get into setup, but I only get a blank screen.

Here is another video:

Thank you!

BobA:
I think you have to set your video to the proper monitor by pressing a button on your board multiple times until the video shows up.   The manual has the sequence.

Navigation

[0] Message Index

[#] Next page

Go to full version