Main > Main Forum
How would i go about suspending things in Custom Sanwa Balltops?
SlayerAlex:
--- Quote from: drventure on May 07, 2010, 12:45:04 am ---the epoxy I'm thinking of dries clear and hard as a rock.
I actually used the bioclear810 on my desk. Stuff is great. you wouldn't need much though.
http://www.epoxyproducts.com/bartop.html
--- End quote ---
oh sweet thanks a bunch. I just checked online and theres a place that sells it close buy. I'll check it out tommorow. If things go well I'll post pics.
opt2not:
--- Quote from: Nannuu on May 06, 2010, 11:17:40 pm ---I've had that idea myself! Futurama and/or Simpsons balltops! Just been too cheap to pony up the money for the stuff. I would think Smooth On would have the right stuff, they have a pretty good selection. Alumalite also has a product that may work.
http://www.smooth-on.com/Encapsulation-and-/c1277/index.html
http://www.alumilite.com/ProdDetail.cfm?Category=Casting Resins&Name=Alumilite Crystal Clear
--- End quote ---
:o
First post in two years! Man, I really stirred up the hornet's nest with that other post huh? ;)
Sorry Nannuu!!!
RandyT:
As someone who has been down this road, let me say it's a tough one to travel. Molding a ball is difficult, but not impossible. However, getting a ball out of a mold with an acceptable finish, is nearly impossible. The balls would need to be ground and polished to get a good finish on them, and that takes special materials and equipment.
RandyT
Hituro:
--- Quote from: RandyT on May 07, 2010, 10:02:45 am ---
The balls would need to be ground and polished to get a good finish on them, and that takes special materials and equipment.
RandyT
--- End quote ---
lol sorry this quote made me laugh. ;D
Navigation
[0] Message Index
[*] Previous page
Go to full version