Main > Main Forum

Ultimarc Aimtrak problem

<< < (3/3)

redpiper1:
OK I got this baby working...Found out it wasn't in the utility or the the PCB & sensor bar...Andy from Ultimarc sensed that I was feeling quite unhappy about the lightgun module and this morning offered a refund and I told him I wanted to goof around with it a little more before we went that route and bam it calibrated...So this is the key: ask for a refund and it will calibrate...Ha ha just kidding...I read another post where a guy thought maybe his monitor was on too much of an angle..Ive got a computer running out to my 46" flat screen LCD and it is tilted toward the floor as far as it will go...So I leveled the TV parallel to the wall and bingo it calibrated...I'm not totally sure this is the answer so I'll test it tonight...

redpiper1:
Tested it last night with the LCD TV flat to the wall and tilted on the wall...It wouldn't calibrate with the TV tilted at all so when I tipped back up parallel to the wall it took...I'm not sure why, maybe the bar tilted toward the gun was tilted way too much or maybe the calibration just couldn't figure the distances correctly or something...The sensor view tab picked it up all the time but once and  a while I would get a weak signal at the bottom no matter what distance I stood from the monitor.Then it would cycle back to the upper left and tell me to check the upper left in the utility...The gun PCB is supposed to have a 30 degree view of the LED bar and maybe with the TV tilted I was way over shooting even though it was picked up in the sensor tab...Anyway, that's my in depth scientific theory...Give it a shot and see if it works for you....

Navigation

[0] Message Index

[*] Previous page

Go to full version