Main > Main Forum
Y-Plus Controller
Hoopz:
You bet you can.
http://ultimarc.com/mp_inst.html
As you can see, the different harnesses connect at different places on the Mini-pac.
D_Harris:
--- Quote from: Hoopz on April 25, 2010, 07:39:11 pm ---You bet you can.
http://ultimarc.com/mp_inst.html
As you can see, the different harnesses connect at different places on the Mini-pac.
--- End quote ---
I guess you missed the couple of times I mentioned that I have the older version of the Mini-PAC. (See pic).
Darren Harris
Staten Island, New York.
Hoopz:
--- Quote from: D_Harris on April 25, 2010, 09:03:25 pm ---
--- Quote from: Hoopz on April 25, 2010, 07:39:11 pm ---You bet you can.
http://ultimarc.com/mp_inst.html
As you can see, the different harnesses connect at different places on the Mini-pac.
--- End quote ---
I guess you missed the couple of times I mentioned that I have the older version of the Mini-PAC. (See pic).
Darren Harris
Staten Island, New York.
--- End quote ---
No I saw that. ::)
On your Mini-pac, the older version, I'm going to bet you can do the same thing. The pins on the left side of your Mini-pac, the older version, are for the optical controls. I'd be curious to see if you emailed Andy and told him you had the older version of the Mini-pac, if you can hook up both at the same time.
Hoopz:
I do sincerely apologize for posting the wrong diagram. It's clearly for the new Mini-Pac, not the old one.
It wasn't that hard to find the old one though.
http://www.ultimarc.com/mp_inst_old.html
But then, I found it easy to find the prices that some others couldn't find. ???
Hoopz:
Here's a quote from Andy (the owner of Ultimarc) where someone asked about the instructions. This may help.
--- Quote from: AndyWarne on February 01, 2009, 04:31:49 pm ---Those are the correct adaptors. You should have had at least one cable with the Mini-PAC, this might be a PS/2 male-male which you can use.
Take a look at this: http://www.ultimarc.com/Mini-PAC%20Manual1.pdf
This is an old manual which was written by someone else, and shows the older version of the board, but the wiring information might help.
Andy
--- End quote ---
Ironically, it was YOUR thread and YOUR question. And as you can see, the pins that I referenced earlier are indeed the optical controls.
:P
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version