Main > Main Forum
New Product: CLASSX™ Pushbuttons - Electric ICE 2 - GroovyGameGear.com
Ginsu Victim:
These are the perfect solution for leafs in a wood control panel.
Epyx:
--- Quote ---These are the perfect solution for leafs in a wood control panel.
--- End quote ---
Agreed, can't wait to try them.
shateredsoul:
--- Quote from: ammitz on March 18, 2010, 04:35:48 am ---
--- Quote from: shateredsoul on March 18, 2010, 02:55:32 am ---one of my questions was answered the other one was about how you light these buttons up... i must be asking an obvious question or something
--- End quote ---
I don't know it either, but I think you can find out by reading in the wiki:
http://wiki.arcadecontrols.com/wiki/Lighting
--- End quote ---
do you think the wiki info still applies to these buttons? They seem to do everything differently than the standard pushbutton.. I was just wondering if they sold a light module to go along with the button (or a set of lights from their site that were made specifically for use with these buttons).
shateredsoul:
Ok this is what I found
this thread http://forum.arcadecontrols.com/index.php?topic=48816.0
which is about the rgb drive that you can buy here http://groovygamegear.com/webstore/index.php?main_page=product_info&products_id=240
Can someone explain the options to me? So let's say I have nothing.. no button, no light, and no wires What do I need? I assume I need the 5.20 option (which includes the electric ice pushbutton, installed rgb led, resistor, board, and conductor cable). Do I connect the conductor cable to my pcs usb? or do I need to connect each button to some other type of board and then to usb?
Bare Board Only
Installed RGB LED and Resistors (+$2.20) (+0.01 lbs)
Installed RGB LED, Resistors and 24" 4-conductor cable (+$2.66) (+0.02 lbs)
RGB Electric ICE™ Pushbutton w/ above. (+$5.20) (+0.06 lbs)
RGB LED and Resistors ONLY! No Board or Wires. (+$0.20)
If I wanted to light up all my p1 an p2 buttons that would be 14 buttons X 5.20 , damn 70 bucks... and I have 8 admin buttons.. hmm gotta start saving =)
Epyx:
The buttons from above *are* from RandyT (www.groovygamegear.com)
If you go to his website you will see the first generation of these buttons all come optional with switches and lighting choice (Novagem).
So if you have nothing...you need the following:
Using Novagems as an example:
-LED-Wiz (Controller that will control the LED on/off etc)
-LED Blinky (Software to control what the LED lights do...intensity/duration/speech sync etc) (Don't need it but its got a ton of cool options).
-Novagem Button with a microswitch (pick one of the options) *AND* pick a colour. The button will come with the PCB LED and resistors etc all mounted and generous length wires...you just need to feed it Vs and plug the ground into the LED WIZ ports
- A Keyboard controller card (either Randys single or dual purpose or competitor like IPAC) to control the buttons own on/off (Pushed not pushed)
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version