Build Your Own Arcade Controls Forum

Main => Software Forum => Topic started by: mark6437 on October 29, 2009, 10:27:53 pm

Title: arzoo: Asteroids, LEDBlinky, Controls Editor = pulling my hair out
Post by: mark6437 on October 29, 2009, 10:27:53 pm

I cannot get Asteroids to speak and blink the right buttons after I assign the buttons in MAME (tab).

I used the controls editor and setup the correct buttons to the correct inputs. I verified that is was right by using the test feature.

Then I go into MAME and assign the same buttons I just setup in the controls editor. Exit asteroids, go back in to asteroids, and all the buttons no longer light up and the speak is off too. However the buttons I assigned in MAME do what they are supposed too, fire, thrust etc. They just no longer speak and blink right.

I went back into the controls editor and verified that my asteroids config was still there.

So what the heck? I know its me doing something real stupid I just dont know what it is.  :banghead:

Plz help arzoo, your my only hope (star Wars refrence)  :notworthy:

Mark

Title: Re: arzoo: Asteroids, LEDBlinky, Controls Editor = pulling my hair out
Post by: arzoo on October 30, 2009, 09:35:41 am

mark - turn on the debug log and verbose options, run Asteroids, and then email me the debug.zip file. Also email me the asteroid.cfg file from the mame cfg folder.

Title: Re: arzoo: Asteroids, LEDBlinky, Controls Editor = pulling my hair out
Post by: mark6437 on October 30, 2009, 09:46:35 am

Ok lemme go turn the cab on. Give me few mins.

Thx

Title: Re: arzoo: Asteroids, LEDBlinky, Controls Editor = pulling my hair out
Post by: mark6437 on October 30, 2009, 10:23:50 am

Email sent