Build Your Own Arcade Controls Forum
Main => Monitor/Video Forum => Topic started by: SNAAAKE on July 17, 2003, 07:57:36 pm
-
..... ???
OK,my monitor have rgb input.
R,G,B,hs,v
the monitor is multi sync.
Can I run vga using this cable?
(http://www.virtualinformation.com/ebay_images/bnctovga-1.jpg)
The back on the monitor look like this.
(http://www.imagestation.com/picture/sraid67/p0e4fc3e37e08cd175402a23730972d02/fbcd4d5c.jpg)
or the rgb input ONLY outputs 15khz?
anyone? :)
See I use a switch box to switch between dreamcast and pc.
I wanna use my remote the switch.
there is 2 vga sockets(15pin) but the bottom one is "vga output".
The switch box works and all but still annoying.why would I use if I can switch with my remote :D. anyhey.....
-
Yes Snack ;) , you can use that cable. That is used for RGB2. RGB1 is for the 15 pin VGA connection. Depending on where you buy that VGA->BNC cable, it could cost you. Look for a cheap price. At best buy it is like $40 but elsewhere online it is like $10-$15. I would have to look at mine when I get home to see about the 15khz. I think it is 30khz also though. Good luck.
J_K_M_A_N
-
oh hey... :)
is there a way you can be sure it does 31 khz ? ???
Dont wanna burn anything AND I had really bad monitor experience before so make sure and post back.
(thanks for that remote again..working great ;D)
-
I will check my manual when I get home.
J_K_M_A_N
-
Well, according to my manual, it says:
Synchronization
Horizontal 15.5 - 38 kHz (Automatically)
Vertical 40 - 100 Hz (Automatically)
So, yes, it should be fine at 31Khz. Good luck.
J_K_M_A_N