Build Your Own Arcade Controls Forum
Main => Monitor/Video Forum => Topic started by: teddyboyblue on October 12, 2009, 04:07:42 am
-
Hello All
I have tried to convert my Virtua Fighter 2 cabinet to a Jamma, but has stumbled on this problem
On my screen wires must be installed like this
GND SYNC B G R
DEM DEM AC AC
DEM to be connected only with SW
1. The top line is no problem, but is there anyone ho can explain to me what the DEM and SW means?
2. AC and AC are just ordinary. phase and zero?
3. Where on the screen can you see how many volts it takes?
Hope you can help me
Regards
Peder
-
DEM= demag switch(degauss switch)-connects to a momentary action switch
Ac volts can be 100-120v-connect either way round-best to connect to an isolation transformer
this is a nanao monitor i presume
-
DEM= demag switch(degauss switch)-connects to a momentary action switch
Thanks for the fast reply
But I am a newbie and don’t know what this is can you explain this to me and maybe how to connect this
Regards
Peder
-
yeah its real basic,the 2 red wires go to a momentary action switch-when you pulse the switch the screen demags
-
yeah its real basic,the 2 red wires go to a momentary action switch-when you pulse the switch the screen demags
Ok but the trouble is that this was an empty cabinet I got , so the wires for the DEM DEM and the AC AC was just hanging there, and I don’t know where to connect them
Can it help if I post some pictures? Maybe on your mail
Regards
Peder
-
mine dont have anything hooked to the degauss nputs and it is not required unless you need to degauss it really.