Build Your Own Arcade Controls Forum

Main => Main Forum => Topic started by: RedSquirrel on July 16, 2003, 06:10:16 pm

Title: Anything I can do to change my panel?
Post by: RedSquirrel on July 16, 2003, 06:10:16 pm

I have pretty much made my panel, but only today released something.

Basically the panel is totally flat. I was going to angle it slightly in the cab. But it was only till today I realised if I do this, its not going to stay straight against the cab.

I could

a) just keep it flat

b) sand down the sides and front and make a small angle. (the hinge would be okay with this right?)

Any other ideas? Thanks

Title: Re:Anything I can do to change my panel?
Post by: REBIRTH on July 16, 2003, 08:53:16 pm

Really need to see some pictures of the CP and cab and how they go together now.

Title: Re:Anything I can do to change my panel?
Post by: night on July 16, 2003, 09:27:16 pm

you mean the back edge against the cab sides right  ?

if you are using mdf and have or can use a small palm sander, the stuff sands down really fast and u can bevel the side enough to make it look better