Build Your Own Arcade Controls Forum
Main => Monitor/Video Forum => Topic started by: bdsjake on July 13, 2009, 07:51:21 pm
-
Hi all, here is my summer project: built a mame cab a few years ago with ArcadeVGA and standard resolution monitor. It is a Vision Pro MTG1901CM (I think, a little hard to read w/o pulling it out of the cab). So, hard drive fail and I decide to try a 48-in-1 board rather than building or buying or fixing the computer.
The monitor has a 6 pin molex type connector going to it (which I had wired to the ArcadeVGA), the wiring harness I bought (from jammaboards.com), if I have it figured out right, has only a 5 pin connector of a different type.
I am guessing the 5 pin combines Horz and Vert sync?
what would be the best way to connect this up? get a new wiring harness? cut and splice the wires together?
any ideas are appreciated, thanks!