The NEW Build Your Own Arcade Controls

Main => Main Forum => Topic started by: Fitznab on June 21, 2009, 10:24:03 am

Title: Construct removable panel
Post by: Fitznab on June 21, 2009, 10:24:03 am

Hello All,

I am building the Ultimate Arcade II.  I notice that once its put together and laminated there is no way to get to the inside, the screws are covered up.  Also I assume after a while the screw holes would wear out.  So what recommendations do you all have on making either the front panel or the back panel removable.

• I thought about just putting in some magnets to hold it in place, but the panel is just too heavy.
• I could put hinges on one side, just have to figure out a way to hide the latch on the opposite end.
  

Title: Re: Construct removable panel
Post by: Dazz on June 21, 2009, 09:34:11 pm

The rear panel is easy to make removable...  I have my rear panel setup with a cam lock.