Build Your Own Arcade Controls Forum

Main => Main Forum => Topic started by: javeryh on June 08, 2009, 03:13:47 pm

Title: Applying DK instruction card on CP?
Post by: javeryh on June 08, 2009, 03:13:47 pm

OK, there is probably something completely obvious that I am overlooking but here goes... how do you line up the DK instruction card on the control panel so it is exactly centered underneath the window in the plastic overlay? 

The first pic shows the blank window and the second pic shows the art laid out on top.  Thanks.   :cheers:

Title: Re: Applying DK instruction card on CP?
Post by: SirPeale on June 08, 2009, 03:34:48 pm

Tape on the edges of the card, sticky side up of course.  Card facing up.  Lower the CPO down and use the transparency to your advantage.  Then lift and secure the tape by rubbing it to remove any air under the tape.

Title: Re: Applying DK instruction card on CP?
Post by: javeryh on June 17, 2009, 06:12:18 am

Heh, I thought the instruction card was a sticker but that doesn't appear to be the case.  Looks like I'll just be using tape around the edges facing up to hold it in place...