Build Your Own Arcade Controls Forum

Main => Monitor/Video Forum => Topic started by: iscariot on May 27, 2009, 01:53:16 pm

Title: bad video on tv tube after move
Post by: iscariot on May 27, 2009, 01:53:16 pm

I'm using an apex 24 inch tv with component. When I moved it I pulled lose a cord and now the video is almost unintelligable. Ideas?  I already recommected the wire

Title: Re: bad video on tv tube after move
Post by: qrz on May 27, 2009, 04:30:10 pm

double check connections.

post pic of symptom

qrz

Title: Re: bad video on tv tube after move
Post by: iscariot on May 28, 2009, 10:47:54 pm

Ok, got good raster after I forced a sync through the component stuff.

However.....

the guy I had resoldering the board messed with 2 trimpots on the yoke board.  They are marked VR1 and VR2 and I need to get them back b/c the red and blue look like they're out of alignment.

Title: Re: bad video on tv tube after move
Post by: qrz on June 03, 2009, 08:38:03 pm

RU sure the convergence rings weren't bumped instead ?