Build Your Own Arcade Controls Forum

Main => Buy/Sell/Trade - non-retail => Topic started by: taternutz on March 20, 2009, 04:24:35 pm

Title: WTS/WTT: DREAMCAST Agetec board US/Fl/daytona SOLD
Post by: taternutz on March 20, 2009, 04:24:35 pm

I am getting ready to open up a agetec dreamcast stick to remove the boards and convert it into a 360 controller. I am checking to see if there is any interest for the board that came out of it.  :cheers:

Just throw it in a project box and you are ready to play minimal wiring needed.

I have not cut the quick connects off yet just in case someone really needs them on the unit but they same button specific for this model.


Cables are marked as follows
A B C X Y Z START GROUND
The cord did not come off of the joystick but it is a 5 pin as seen on the right hand side

$20 shipped OBO

Title: Re: WTS/WTT: DREAMCAST Agetec board US/Fl/daytona
Post by: taternutz on March 26, 2009, 11:23:24 pm

Shamless bump

Title: Re: WTS/WTT: DREAMCAST Agetec board US/Fl/daytona
Post by: taternutz on April 03, 2009, 07:06:43 pm

one last bump till it goes into the bucket to be never seen again...