The NEW Build Your Own Arcade Controls

Front End Support => MaLa Frontend => Topic started by: Ummon on March 14, 2009, 05:40:18 pm

Title: Ultrastik mapper question
Post by: Ummon on March 14, 2009, 05:40:18 pm

Is there a way to turn off the 'no ultrastik connected' warning?  A ---smurfette---, but I love Advancemame too much not to use it, despite its issue with Trackball versus analog stick, and though I have to un-plug the stick each time I use trackball games, having to click at load and exit of the game just adds insult to injury - which is no fault of MaLa or the mapper, of course, but a hindrance I'd like to avoid if possible?

Title: Re: Ultrastik mapper question
Post by: TheShanMan on March 15, 2009, 12:08:27 am

Looking back, I think the way I got the messages to go away was to uncheck the "required" checkboxes in the ultramap options window. It was just as much of a concern to me because I have swappable panels so my u360's aren't always hooked up.

Title: Re: Ultrastik mapper question
Post by: fatfingers on March 16, 2009, 04:48:12 pm

Yes, you must uncheck the 'required' option.

Good luck.

Title: Re: Ultrastik mapper question
Post by: Ummon on March 16, 2009, 05:09:54 pm

I didn't see any options to check in loading the app, and I looked all over inside the MaLa 'options' and didn't see where that is. Can you tell me?

Title: Re: Ultrastik mapper question
Post by: Orclord on March 16, 2009, 05:31:22 pm

Hi...

It's nothing to do with MaLa...

Start ultramap.exe from it's install Dir......Go to Tools......It's under options........

Title: Re: Ultrastik mapper question
Post by: Ummon on March 18, 2009, 05:01:23 pm

OH. Thank you.