Build Your Own Arcade Controls Forum

Main => Main Forum => Topic started by: Chris2 on December 25, 2008, 05:38:07 pm

Title: How do I install a SpinTrak?
Post by: Chris2 on December 25, 2008, 05:38:07 pm

I've been scouring Ultimarc and the BYOAC wiki, but I haven't found anything about how I would install the spinner. I have a 3/8" - 7/16" hole on my panel, and I don't know how I could make the spinner stay in place with such a hole.

Also, how do you fit the spinner head on top? I try using the screws from the flywheel, but they go right through the holes.

Title: Re: How do I install a SpinTrak?
Post by: blind_dado on December 26, 2008, 12:12:59 am

The SpinTrak fits into a standard 1-1/8" hole.  The spinner top should have two set screws in it that tightens against the shaft.  There are some pictures here that might help:

http://forum.arcadecontrols.com/index.php?topic=83463.msg871860#msg871860 (http://forum.arcadecontrols.com/index.php?topic=83463.msg871860#msg871860)