Build Your Own Arcade Controls Forum
Main => Main Forum => Topic started by: weasel on December 08, 2008, 09:54:34 am
-
I have a small poker cabinet that was turned into an arkanoid. But now Id like to turn it into a 60-1 but would like some knowledgeable opinions on a good control panel. I assume I only need three buttons and a stick but I would like to add a spinner just trying to figure out where everything should be placed. As info the cp is 19 inches long. Any advice appreciated
-
My CP is 44cm wide (17.3") and whilst I have to admit that the cabinet has yet to be used in its current iteration, I've fitted all of this on. The you take a look at the most recent photo here (http://forum.arcadecontrols.com/index.php?topic=38343.msg914366#msg914366), this should give you some idea of how I've done it. The start buttons and credit button aren't on the same surface, but I don't see that there's any need to have them all grouped with the game controls.
-
Agreed. Check out the cabinets we build for an idea of how controls can be mounted in a limited space, yet still look uniform. Although we've never done a panel so small with a trackball, simply dropping it in place of where player 2 would usually be should be fine, assuming the surface panel is deep/wide enough to accommodate the trackball you intend to use, and you account for the large interior space the trackball housing takes up inside the control panel section. I highly reccommend the U-Trak from Ultimarc for it's 'contained' housing, easy mounting and lack of a need for a mounting plate.
-
(http://forum.arcadecontrols.com/index.php?action=dlattach;topic=51525.0;attach=109700;image)
I am working on this and the cp is only 15" wide the U-track is the only full size trackball that would come close to fitting in mine and I still thad to modify it a bit to squeeze it in
the game play is quite comfortable except the joystick is a little too close to the left side