Build Your Own Arcade Controls Forum

Main => Main Forum => Topic started by: Epyx on November 23, 2008, 07:26:08 pm

Title: Mag Stik Plus Assembly Picture
Post by: Epyx on November 23, 2008, 07:26:08 pm

I was carefully (well trying) to take apart the Mag Stik Plus but the force of the spring pushed the parts out before I could see the order...anyone have a picture of the order for re-assembly? I have two washers with teeth that I am the most concerned about (with regards to order).

Thanks in advance...

Title: Re: Mag Stik Plus Assembly Picture
Post by: paulscade on November 23, 2008, 08:52:55 pm

When I tool mine apart... I placed the parts on the table in order... hope this helps...

http://forum.arcadecontrols.com/index.php?topic=82241.msg891255#msg891255

I believe that the toothed washers were on the inside of the u shaped part.

Title: Re: Mag Stik Plus Assembly Picture
Post by: Epyx on November 23, 2008, 09:07:39 pm

Awesome. Thanks very much!

Title: Re: Mag Stik Plus Assembly Picture
Post by: AndyWarne on November 24, 2008, 11:19:02 am

There is a full diagram on http://www.ultimarc.com/controldiags.html (http://www.ultimarc.com/controldiags.html) if you still need any info.
Andy

Title: Re: Mag Stik Plus Assembly Picture
Post by: opt2not on December 05, 2008, 02:15:08 pm

Hey Andy, do you sell the Mag Stik Plus replacement shafts alone?  Without balltops?

I've got a few spare balltops I want to use, but I don't want to go through the hassle of trying to breakthrough the locktite seal of the balltop shafts you supply off your site.

Thanks!

Title: Re: Mag Stik Plus Assembly Picture
Post by: Epyx on December 05, 2008, 03:49:11 pm

Thanks Andy!

Title: Re: Mag Stik Plus Assembly Picture
Post by: AndyWarne on December 06, 2008, 07:33:14 pm

Yes we could supply the shafts on their own, we can arrange this if you drop me an email: andy@ultimarc.com