Build Your Own Arcade Controls Forum
Main => Main Forum => Topic started by: Rec Room supply on October 29, 2008, 11:02:47 pm
-
hi, i have an arcade marquee that blows a fuse when i replace the flourescent bulb. i see a coil of sorts in the light fixture. is this possibly a step down convertor or something and its not 110 volts? there is inline to the bulb a tiny light bulb in the wiring that lights so im assuming that shows i have power? does that have to remain in the wiring or can it be cut out? but the actual light never lights, just blows a breaker. can i fix this or possibly just cut this one out and replace it with a new flourescent fixture from my local store?........Scott
-
The coil thing you are referring to is a ballast and is probably what is bad and causing your fuse to blow. The light bulb looking thing is a starter and is used to provide the extra boost to initially light the bulb. Personally I would just replace the entire fixture since it is not working.
-
thanx for the info, do i KEEP the starter in the circuit or cut out the whole thing and direct wire the new fixture?........Scot
-
The starter is 100% necessary, or your bulb will never light.
Just get a replacement @ Wal-Mart for $8.00.
-
What is the fuse? How much current does the machine use? The starter gives a boost to the current flow after starting up. The fuse must have enough reserves. Try keeping the marquee outside the fused part of the cab, and give it 110 directly.