Build Your Own Arcade Controls Forum

Main => Main Forum => Topic started by: rusolinio on October 23, 2008, 01:24:20 pm

Title: Arcade VGA and J-pac issue.
Post by: rusolinio on October 23, 2008, 01:24:20 pm

Hi guys,

  I just hooked up the Ultimarc Arcade vga card to a j-pac inside my ki2 cab with a wells gardner U2000 monitor, and i get no picture.

I'm assuming its because i didnt set the resolution correctly, so could someone tell me a good resolution to start off with  for games like killer instinct, mortal kombats, etc...?

Failing my assumption, can anyone shed any further light in regards to my issue?

Title: Re: Arcade VGA and J-pac issue.
Post by: CheffoJeffo on October 23, 2008, 01:55:49 pm

How are the jumpers on the JPac set and what is the sync indicator LED doing ?

Title: Re: Arcade VGA and J-pac issue.
Post by: AndyWarne on October 23, 2008, 01:58:56 pm

The most common issue is the J-PAC is not connected to the PC USB or PS/2 port so has no power.

If this is not the problem, its better resolved by email: andy@ultimarc.com

Title: Re: Arcade VGA and J-pac issue.
Post by: rusolinio on October 23, 2008, 02:17:31 pm

The jumpers are set at default (15khz and 31khz). i have a 'sync in' amber light on, and the self test led is on constantly (red).

i did notice the ps2 port was a little hard to push in, but i made sure it was in all the way.

Email sent.