Build Your Own Arcade Controls Forum
Main => Main Forum => Topic started by: georgemcfly on September 12, 2008, 12:02:35 pm
-
When you wire in a 4 way joy and 2 buttons, are they just spliced into the player 1 up/down/left/right and 1/2 buttons? I was planning on going with a small 2 player layout but wanted a setup for old games as well. If its that easy, I'm modding my CP layout.
-
You don't need to splice the wires, but you can easily connect two wires to the inputs for P1 Joy and buttons. It's a simple step to take.
-
wire both wires into the input on my ipac2 for the shared ones?
-
wire both wires into the input on my ipac2 for the shared ones?
yes. I did that with some push buttons.
-
wire both wires into the input on my ipac2 for the shared ones?
Or I believe that you can run wires between the shared connections, and just attach one to the IPAC, rather than wiring each separately to the IPAC.
-
I ran mine to a common block - they have them at radio shack and then ran a wire to the ipac. A lot of different ways to do this.
-
wire both wires into the input on my ipac2 for the shared ones?
yes. I did that with some push buttons.
Yep. I think it's the easiest way. Simply putting two wires into the screw terminals saves time/effort. No splicing, combining etc. Just pop em in, screw them down, and start playing!
-
awesomeness. Now I have no reason not to add spinner and 4way.