Build Your Own Arcade Controls Forum

Main => Woodworking => Topic started by: Jm1010 on September 08, 2008, 09:37:41 pm

Title: T Molding Question
Post by: Jm1010 on September 08, 2008, 09:37:41 pm

Hi All . I am working with MDF and a layer of laminate for my control panel.  Should I find the center of the Mdf sheet or include the laminate also in the calculation? IE do you want the T mold to end just below the laminate or flush with it?

thanks everyone!

JM

Title: Re: T Molding Question
Post by: somunny on September 09, 2008, 12:27:48 am

I think its a preference question, really.  I normally laminate both sides so I cut the channel in the center of the mdf.  That way I have an equal amount of overhang on each side (about 1/32").