Build Your Own Arcade Controls Forum

Main => Monitor/Video Forum => Topic started by: yukonblaze on September 03, 2008, 04:32:30 pm

Title: WG4900 Foldover!!!
Post by: yukonblaze on September 03, 2008, 04:32:30 pm

Have a slight foldover on right side of monitor (about 1/16th of screen).  I did a cap kit with no resolve.  Was wondering if there are any other caps, that arent usually part of cap kit that should be changed??

Thanks

Title: Re: WG4900 Foldover!!!
Post by: Ken Layton on September 03, 2008, 04:39:35 pm

Is this a horizontally mounted monitor or vertically mounted?

Title: Re: WG4900 Foldover!!!
Post by: yukonblaze on September 03, 2008, 04:49:05 pm

My apologies, it is mounted vertically (TRON)!! :P

Title: Re: WG4900 Foldover!!!
Post by: Ken Layton on September 03, 2008, 05:32:35 pm

If your version of the 4900 is equipped with a "Vert Damp" control, adjust it.

Title: Re: WG4900 Foldover!!!
Post by: yukonblaze on September 03, 2008, 06:37:26 pm

Will give it a shot when a friend can stop by to help.  Wife would usually help, but always ends up worse than it started.

Title: Re: WG4900 Foldover!!!
Post by: yukonblaze on September 08, 2008, 06:54:19 pm

Adjusted vert damp without resolve.  Have been told to switch out 306 as my cap kit didnt include (306).  I have a 2.2 50v left from recap, but electrolyc vs tantal??  Dont know enough to know if this will work.

Thanks