Build Your Own Arcade Controls Forum

Main => Main Forum => Topic started by: opeo on August 26, 2008, 12:15:52 pm

Title: Newbie: Second LED-Wiz not detected, except with LumAura?
Post by: opeo on August 26, 2008, 12:15:52 pm

Hi all,

I have two LED-Wiz controllers hooked up and cannot access the second LED-Wiz using LEDBlinky or with the SDK demos. Both controllers are visible in the Device Manager as HIDs but every time I start up AnimationEditor the 'One or more LED-Wiz devices required by the Device/Port Input Map was not detected' message appears. When running SDK demos, the Active Device List button only shows a '1' in the left-most position.

The odd thing is, I am able to run an LWAX animation on the first controller using LEDBlinkyAnimationEditor (and SDK demos) and turn LEDs on/off on the second controller using LumAura panel that comes with LED-Wiz control panel.

Any help would be much appreciated.

Cheers,
opeo

Title: Re: Newbie: Second LED-Wiz not detected, except with LumAura?
Post by: arzoo on September 08, 2008, 08:57:59 am

Quote from: opeo on August 26, 2008, 12:15:52 pm

Hi all,

I have two LED-Wiz controllers hooked up and cannot access the second LED-Wiz using LEDBlinky or with the SDK demos. Both controllers are visible in the Device Manager as HIDs but every time I start up AnimationEditor the 'One or more LED-Wiz devices required by the Device/Port Input Map was not detected' message appears. When running SDK demos, the Active Device List button only shows a '1' in the left-most position.

The odd thing is, I am able to run an LWAX animation on the first controller using LEDBlinkyAnimationEditor (and SDK demos) and turn LEDs on/off on the second controller using LumAura panel that comes with LED-Wiz control panel.

Any help would be much appreciated.

Cheers,
opeo

Sorry for the delay getting back to you on this - somehow I missed this post. When you ordered the two LED-Wiz controllers, did you specify different Device IDs?