Build Your Own Arcade Controls Forum
Main => Woodworking => Topic started by: jeffhlewis on June 26, 2008, 12:59:10 am
-
I've got a time dilemma on my hands here....I ordered a 1/16th slot cutter from Amazon (couldn't find one anywhere here strangely between Menards, Home Depot, Lowes, and True Value) and the ---daisies--- aren't going to ship it until like the last day in June - with an expected arrival between July 1st and 7th (ugh). I'm moving in about a month so every weekend I get I have to be out in the garage finishing this project up. My two sides have been cut even with a router and I've been working on getting tack strips cut for my initial mounting.
My question is - can I just run the slot cutter over the sides once the cabinet is assembled (but unpainted)? I figure it might be a bit more cumbersome than doing it prior to assembly but I don't have time to idle around for another week.
thanks!
-
If you can run of the edge with it: yes, if a part that needs T-bolding is locked between two other panels, than: no. Just go along the edges with the router to imagine what will work when you get to the T-molding point.
-
Just make sure there will be no screws/nails etc in the cutter path, you dont want the cutter hitting one of those at ~20,000RPM.
-
That's pretty much what I thought but I figured I'd consult the experts first. What I should actually probably do during my downtime is get my blog site finished so I can post a worklog, haha. Or better yet actually announce the project on this forum.
I don't have any interior T-Molding (my control panel is recessed) so it should be a problem - just the two sides.
-
Just make sure there will be no screws/nails etc in the cutter path, you dont want the cutter hitting one of those at ~20,000RPM.
This is paramount! An off-the-shelf 1-78" slot cutter will have a 1/2" depth of cut. Wear those saftey glasses!
-
slot cutting is complete...I got it sooner than expected and got everything taken care of before assembly. thanks though, guys!