Build Your Own Arcade Controls Forum
Main => Woodworking => Topic started by: Retro_SA on May 08, 2008, 01:47:21 am
-
Ok, so I couldn't find a small enough bit to cut the grooves for my t-molding. I ended up buying a slightly bigger bit than what I needed. So now the grooves are a bit too big for the t-molding. Is there a easy way to fit the t-molding? Glue will be too messy and I don't have anything to keep the molding in place while the glue dries. Tried silicon as well, but again can't keep it in place to dry. Any ideas?
-
Put in silicon, let it dry, then put in the T-molding?
-
You can't use silicon and use tape to keep it in place?
What about using hot glue?
-
I already tried silicon, left it for an hour before putting in the molding, but it's still not a good fit. It stays in place, but you can see the molding lifting out a bit from the sides.
-
Should have used hot glue. It cools quickly, so it stays in place. Silicone takes too long to cure.
-
refill the grooves with bondo, go get the correct slot cutter bit, and start over.
-
refill the grooves with bondo, go get the correct slot cutter bit, and start over.