Build Your Own Arcade Controls Forum
Main => Main Forum => Topic started by: Franco B on May 02, 2008, 07:16:07 am
-
I have a couple of N64/PSX > USB adapters that I wish to extend the switch on.
This is the switch in question.
(http://img.photobucket.com/albums/v325/Francoberasi/n64adapt1.jpg)
I guess I could just desolder it and run wires from the new switch position to the PCB but I would like to buy a nicer switch to replace it with. Will the switch be single or double pole?
This is the switch I would like to 'replace' it with, its a sub minature DPDT slide switch, would it be suitable?
(http://www.maplin.co.uk/images/300/ff79l.jpg)
This is a picture of the underside of the PCB if it helps:
(http://img.photobucket.com/albums/v325/Francoberasi/n64adapt2.jpg)
If I label the pins:
123
456
it only looks as if pins 3, 4 and 6 are connected, is that correct?