Build Your Own Arcade Controls Forum
Main => Buy/Sell/Trade - non-retail => Topic started by: Thenasty on April 24, 2008, 01:06:52 pm
-
I still have some of this left, and still made some more. When I see ppl throw away there old monitors, and I happened to be driving by, I go and clip the cable off and make the "ARCADE VGA BREAKOUT CABLE".
This are still for FREE just cover the cost of $6.00 for s/h.
-
hey how many wires are there? I need to go from my JAMMA harness to my signal converter. If those wires matched my harness this would be great!
-
R G B Gnd SYNC (H/V) so 6 thats the standard CGA Arcade monitors, some monitor needs the H/V Sync to be twisted to get composite.
-
ok what I need it for is to go from my JAMMA harness to my signal converter
http://www.ambery.com/rgbcgatovgac.html
here's a pic of my JAMMA video connector. I am hoping I can match wires after I remove the plastic piece off of the JAMMA jarness video connector.
-
you have
R (red) G (green) B (blue) Gnd (Black) and the WHITE is COMPOSITE so, you need the H/V SYNC twisted.
-
Can you do one for me plz? :notworthy: :notworthy: I'll even send extra. Paypal info plz
-
Can you do one for me plz? :notworthy: :notworthy: I'll even send extra. Paypal info plz
I have some of them all ready to ship..... I don't have paypal, only cash/money order, thats what I have been accepting here for years....
-
Here is a pic of one....
-
I have put this in the FREE section.......So this thread can reach bottom.....