Build Your Own Arcade Controls Forum

Main => Main Forum => Topic started by: koolmoecraig on April 23, 2008, 10:23:52 pm

Title: U360 Shift Function PROBLEM
Post by: koolmoecraig on April 23, 2008, 10:23:52 pm

I have my U360 updated to the latest firmware(2.4) which is supposed to have shift functionality.  I am having a weird problem.

Button #8(Violet Wire) on the U360 button harness is supposed to trigger shift mode when held down.

In Windows while doing a button test, the button I have hooked up to the #8 Violet wire shows up as it should as button #8.

When I am in Mame trying to configure buttons, that same button is showing up as Button #7. Therefore I obviously cannot use the shift function.

Anyone have any idea what would cause this???????

Title: Re: U360 Shift Function PROBLEM
Post by: Ginsu Victim on April 24, 2008, 08:17:02 am

Test the other wires by touching them to the ground wire and see which one shows up as button 8. It could just be a wiring error on the manufacturer's part.

Title: Re: U360 Shift Function PROBLEM
Post by: destructor on April 25, 2008, 02:30:51 am

In Windows bottons are numbered 1-8, in MAME 0-7.

Title: Re: U360 Shift Function PROBLEM
Post by: Ginsu Victim on April 25, 2008, 08:23:11 am

^That is true.

Title: Re: U360 Shift Function PROBLEM
Post by: koolmoecraig on April 25, 2008, 12:24:18 pm

Quote from: destructor on April 25, 2008, 02:30:51 am

In Windows bottons are numbered 1-8, in MAME 0-7.

Good call.

Thanks.