Build Your Own Arcade Controls Forum

Main => Main Forum => Topic started by: Stormrider on March 20, 2008, 11:56:35 am

Title: PSX pad hack wiring
Post by: Stormrider on March 20, 2008, 11:56:35 am

I've drawn this in FreeHand. I hope it's free of mistakes. I plan on using it as a guide for my cp pad hack and the wiring of my control panel. I could even print it in vinyl and paste it on the inner face of the cp base. It may be useful in case of repair or maintenance.

(http://www.alvarezeninternet.com/temp/wiring.gif)

Title: Re: PSX pad hack wiring
Post by: Stormrider on March 21, 2008, 04:43:13 am

And now, the full wiring of my new CP. I think it's clear enough. It's a good idea to plan this before, because now I know the best way to route the wires.

Drag the picture to another window or save it to disk for full view.

(http://www.alvarezeninternet.com/temp/full-wiring.gif)

Title: Re: PSX pad hack wiring
Post by: Stormrider on March 23, 2008, 12:38:05 pm

I've just updated the drawings because I had drawn them from the top side view, when I had to do it from the downside view. Now it's correct. I've also shown exactly the route of every wire including those that go to the action buttons and coin and start, although in the actual instalation they will be all very close together, but since this is schematic, it's better to show them this way.