Build Your Own Arcade Controls Forum
Arcade Collecting => Miscellaneous Arcade Talk => Topic started by: CEE1281 on February 16, 2008, 03:31:25 pm
-
First off i hope this is the right section to post this ? if not my bad.I have a golden tee 2005 green board and im trying to hook up a new power supply.there is 2 9 pin connectors and 1 three pin connector coming off the power supply.i know where the 3 wire connector goes to but the 2 9 pin connectors im not sure.I know there is a 9 pin connector going from the board to i believe the hard drive and i know one of the 9 pin connector off the power supply hooks up to it but im not sure which of the 2 connectors off the power supply hook up there.i dont want to hook them up backwards and fry something.i appreciate any help.thanks.
-
It really doesn't matter. They are all wired the same, as long as nobody has altered them. One 9 pin is used to power the board/hard drive assembly and one is used to power the led sign. There was also a wiring upgrade made to these boards that powered the board through the 4 pin molex connectors on the board rather than through the edge connector.
-
Contact tech support at the manufacturer www.itsgames.com