Build Your Own Arcade Controls Forum
Main => Main Forum => Topic started by: Game-boi on January 26, 2008, 03:17:00 pm
-
Hi all- I bought a Gauntlet Legends cab from an arcade. It was completely working when I left the arcade, unfortunately I had to bring it back two hours and then get it up 10 steps into the house. I wasn't rough on it, but of course it took a few bumps along the ride. Now, when I power it on, I hear a "bong" and I hear the hard drive, all the lights come on, but the monitor doesn't. Not sure what diagnostic info. I can provide, as this is a first time for me. Anyone have any advice? I have no idea where to start :(
-
I just opened it up and noticed it is a K7500 monitor and I do hear some very light ticking. Maybe it's just a monitor problem, but even after reading a few posts here, I'm not sure where to begin...is there an "easy" part to replace? Are there service techs to fix this stuff? I am local to MA if anyone has any suggestions at all, I am open to them.
Thanks!
-
Ok...new news...it's up, maybe it was just cold??? It's a little off-position, but I have the manual so I can figure out how to fix that. Any ideas on how to change the volume levels? This thing is loud ;D
-
Most likely the volume controls are on the inside near the coin door...sometimes it is mounted right on the coin door.
-
No go, lots of controls for the monitor, but no obvious knobs or dip switches for sound/test modes, etc. Thanks though.
-
I found the manual online for you:
http://www.basementarcade.com/arcade/library/manuals/g/gauntletlegends.pdf (http://www.basementarcade.com/arcade/library/manuals/g/gauntletlegends.pdf)
According to it, there are buttons for volume up and down on a bracket behind the coin door. How many people did you have help you move that sucker? According to the manual, it weighs 450 lbs.