Build Your Own Arcade Controls Forum
Main => Main Forum => Topic started by: Justin Z on January 05, 2008, 08:04:57 pm
-
These are really tiny connectors. Anyone out there who has this style button have a suggestion for finding the proper sized quick disconnects (if they exist) or any other alternative to soldering?
Thanks,
Justin
-
Solder them. If you're building custom stuff, or restoring a game of that age, you should know how to solder leaf contacts. It's not hard.
-
No, it's not.
That said, since nothing else in the entire CP is permanent, I'd rather have the ability to change these if I feel like it as well.
If that's not possible, that's fine, but I'd prefer the option one way or the other.
-
I've never hooked up volcano buttons...
Although, I've had good luck using regular sized quick connects on small pins.
You might have to adjust them with a pliers a little for a good friction fit.
In other words, just use half of a quick connect pinched with a pliers.
-
That sounds like it's worth giving a shot, thanks.
-
I've never hooked up volcano buttons...
Although, I've had good luck using regular sized quick connects on small pins.
You might have to adjust them with a pliers a little for a good friction fit.
In other words, just use half of a quick connect pinched with a pliers.
That's what I did with mine.
Since then I have seen 3/16" QDs at Radio Shack, so smaller ones do exist if you want to go to the trouble.
-
I don't know their size, but I used the smallest disconnects that I found in my stockpile of arcade related parts for my Centipede volcano's....
(http://gallery.mac.com/andre.huijts/100081/DSCF0426/web.jpg)
They fit quite well and don't come loose.
-
That's what I did with mine.
Since then I have seen 3/16" QDs at Radio Shack, so smaller ones do exist if you want to go to the trouble.
3/16" = .187", i.e. the size for normal button and joystick microswitch tabs, which I would assume is too wide.
They do make very narrow QD's (I would guess 1/8"). Check your local car audio shop. A lot of car audio speakers have a normal 1/4" QD tab and a very narrow QD tab (looks to be about half the width). This is to prevent the installer from accidentally reversing the polarity of the speakers. I've bought some of these very narrow QD's from a local car audio place for my car speakers, and it is the only place I've ever seen that had them. They look just like the typical crimp-on half-insulated QD's, except about half the width.
Edit: It looks like Mike's Arcade has them - http://www.mikesarcade.com/cgi-bin/store.pl?sku=QD110RED
(http://www.mikesarcade.com/store/photos/qd110red.jpg)
Don't know if that's the right size for volcano button switches or not—you'd have to measure the width of the tabs.
-
A .110 disconnect is what I used on a custom CP fro a freind 2 years ago and they still hold just fine.