Build Your Own Arcade Controls Forum
Main => Monitor/Video Forum => Topic started by: Doughbroz on December 18, 2007, 10:29:32 am
-
Just in case anyone has this same symptom. Problem was hula with a sharp edge that looked like an earthquake printout moving from bottom to top of horizontally mounted monitor. Normal cap kit didn't help, but the last thing I could possibly try with parts on hand was the cure. Replaced the cap next to the largest one(680uf) on the board. I think the faulty one was 100uf@100v. Also took a while to find cap #305, which appears to be #306 on the solder side, and is nearly invisible on the parts side, although it is correctly numbered. Finally, there was a slight horizontal tear at the top of the picture that no adjustment could remove. Jumpering the + and - neg sync cured that. Happy capping.