Build Your Own Arcade Controls Forum

Arcade Collecting => Miscellaneous Arcade Talk => Topic started by: shilmover on November 12, 2007, 12:57:37 pm

Title: T-Molding question
Post by: shilmover on November 12, 2007, 12:57:37 pm

is there an "average" amount of T-Molding for Arcade games?  A couple of my games are hard to get to and I was hoping to estimate and place a single order to save on shipping.

Title: Re: T-Molding question
Post by: eccs19 on November 12, 2007, 02:31:52 pm

I would just measure the overall height of the cabinet, and the depth of the cabinet.  If it has lots of curves in it, add a few feet for good measure.

Title: Re: T-Molding question
Post by: shilmover on November 12, 2007, 04:16:24 pm

Thanks...  I was hoping to not have to move everything around to get to them.  Any one know what lengths an Upright SW and a DKJr cab requires?

Title: Re: T-Molding question
Post by: SirPeale on November 13, 2007, 05:13:16 pm

They come in 20 foot lengths.  More than enough for one average cabinet.

Title: Re: T-Molding question
Post by: shilmover on November 14, 2007, 03:13:37 am

Quote from: Peale on November 13, 2007, 05:13:16 pm

They come in 20 foot lengths.  More than enough for one average cabinet.

Coolness!  Thanks.  :notworthy:

Title: Re: T-Molding question
Post by: ChadTower on November 14, 2007, 02:15:24 pm

And it's cheap enough that if you order twice the amount you need it won't hurt any.

Title: Re: T-Molding question
Post by: shilmover on November 15, 2007, 03:35:39 am

Quote from: ChadTower on November 14, 2007, 02:15:24 pm

And it's cheap enough that if you order twice the amount you need it won't hurt any.

Good point!  Thanks everyone!