Build Your Own Arcade Controls Forum

Main => Main Forum => Topic started by: steveh on November 04, 2007, 02:28:28 pm

Title: Need template for over under coin door
Post by: steveh on November 04, 2007, 02:28:28 pm

I have 2 over under coin doors, and i need a template so i can cut the front of my cab.  if any one has one, or can tell me when i can find one that would be great.

i am pretty sure this is the door i have (or at least something very similar to it.

http://www.happcontrols.com/coindoors/40003800.htm

thanks in advance.

Title: Re: Need template for over under coin door
Post by: Red 5 on November 04, 2007, 02:34:56 pm

You could use the hole cutout diagram on the page that door is on.

http://www.happcontrols.com/coindoors/40003800_exploded.htm

Jon

Title: Re: Need template for over under coin door
Post by: steveh on November 04, 2007, 02:38:52 pm

i am really looking for something i can print out and tape to it, and just cut it out that way.

Title: Re: Need template for over under coin door
Post by: Red 5 on November 04, 2007, 02:41:17 pm

Quote from: steveh on November 04, 2007, 02:38:52 pm

i am really looking for something i can print out and tape to it, and just cut it out that way.

I will draw you one in AutoCad and post a .jpg

Ok?
Jon

Title: Re: Need template for over under coin door
Post by: Red 5 on November 04, 2007, 02:59:53 pm

I had to go PDF on it but if you print 1 to 1 it should work.

I left the measurements on there so you could check it.

Have Fun,
Jon



edit - I really need to learn grammer

Title: Re: Need template for over under coin door
Post by: steveh on November 04, 2007, 03:57:25 pm

thank you i think this should work fine :)