Build Your Own Arcade Controls Forum

Main => Main Forum => Topic started by: JoyMonkey on November 03, 2007, 12:03:31 pm

Title: SpinTrak mounting pattern?
Post by: JoyMonkey on November 03, 2007, 12:03:31 pm

I'm putting together a control panel but don't have an Ultimarc SpinTrak at hand to measure how far apart the mounting holes are spaced.

Does anyone know what the distance is from center to center of the 4 mounting holes?

Title: Re: SpinTrak mounting pattern?
Post by: genesim on November 03, 2007, 01:23:23 pm

I have the Spintrak but what are you needing??

The center to center?   

Title: Re: SpinTrak mounting pattern?
Post by: genesim on November 03, 2007, 01:28:42 pm

I measured about 2 inches apart with the wholes being roughly a quarter inch in.

So the holes are roughly 1.5 inches apart.

Title: Re: SpinTrak mounting pattern?
Post by: JoyMonkey on November 03, 2007, 01:31:19 pm

Thanks for checking.

I shot Andy from Ultimarc an email too; the official word is that they're 42mm (a hair over 1 5/8") apart.

Title: Re: SpinTrak mounting pattern?
Post by: genesim on November 03, 2007, 01:45:15 pm

That seems a little far. 

If you want to get it down to the wire, I go with 1 9/16

(http://img.photobucket.com/albums/v27/genesim/DSC00648.jpg)

Title: Re: SpinTrak mounting pattern?
Post by: genesim on November 04, 2007, 11:14:46 pm

I was hoping you saw this before you drill your holes!   Though I would always wait till you get the hardware first.