Build Your Own Arcade Controls Forum

Main => Monitor/Video Forum => Topic started by: GIjoe on October 21, 2007, 12:45:40 am

Title: Replacement Yoke Connector/Wires?
Post by: GIjoe on October 21, 2007, 12:45:40 am

Hey all,

I was working on a K7000 chassis the other day that needed a yoke flip. Forcing the Blue/Red down at angle, I cracked the connector a bit. After fidgeting around with the darn thing for another 10 minutes, I managed to completely break the away the surrounding plastic leaving me with the loose wires. I would like to think the connector was brittle and the faults not all mine but I was sure someone would post otherwise  :D

Are replacement yoke wires with the connector already attached available anywhere?

Thanks,    - Joe

Title: Re: Replacement Yoke Connector/Wires?
Post by: qrz on November 13, 2007, 10:48:38 pm

in 25+yrs of tv servicing, never had a replacement yoke w/out the leads....

u might watch on trash day for junk (i.e. donor) tv's-comp monitors . u may well find the connector
u need . or just solder leads direct to pcb.

note: the typical a63 xxx crt will work in most monitors.  may need to use spacers as some mouning tabs are reversed .  but the price is right !!

qrz