Build Your Own Arcade Controls Forum

Main => Monitor/Video Forum => Topic started by: Solvalou on July 10, 2007, 09:38:51 am

Title: Width Coil Problem
Post by: Solvalou on July 10, 2007, 09:38:51 am

Hi!

I got a Electrohome G07 19".
If I twist the screw of my with coil nothing on screen changes. Should it regulate the size or what?
The PCB sends a comp Sync Signal, but my screen supports only VSync and HSync, or Negative V- and HSync.
So I decidet to put a Bridge on the connector between V- and Hsync, the picture is perfect!
But the size and the position isnt correct. Can I do it a other way?

Thanks for your help!

Title: Re: Width Coil Problem
Post by: cw on July 10, 2007, 03:30:36 pm

the width coil on a g07 does very little as far adjusting the size I have found.  A 1/2" at most
will be gained or lost with it.  You can however get Bob Roberts horizontal width kits ....
http://therealbobroberts.net/width.html

all the info is in the link...

hope this helps