Build Your Own Arcade Controls Forum
Main => Main Forum => Topic started by: Hawk Daddy on June 28, 2007, 07:54:52 pm
-
I need to check the voltage on my power supply. I have a digital meter, and I would like to know what setting I use to check the voltage. Also what do I use as test points? I was thing just connecting it to the positive, and negative on the switcher. BUt I need to know what setting to set it on for the meter to read less then 5.5. cause I don't want to mess up my new board.
Hawk
-
You should set the meter to read HIGHER than the expected output voltage. Most meters have a 20 volt setting. Use that. Put the black to black, and the red to red, and you should be set.
-
I'm talking about like, acv, dcv, ohm, dca, and then like 500v, 200v, 20v, 2v, cause I'm pretty sure it has to be on DCV, then I need to know if i need to check it with 500v, 200v, 20v, or 2v, setting, and then what am I looking for when I do, I'm a complete noob at checking voltages.
Hawk
-
I think I got it, I put it on 20v, and got a reading of 5.29. Is that too high, the board that I have says not over 5.5 v, and 5.29 isn't that far away from it. Just let me know.
Hawk
-
I think I got it, I put it on 20v, and got a reading of 5.29. Is that too high, the board that I have says not over 5.5 v, and 5.29 isn't that far away from it. Just let me know
Hawk... 5.29V is way less than 5.5V don't worry, that's fine. If you're measuring the power supply output under a no load condition (i.e. you don't have anything but the meter connected to it) then it will read more than 5V .... But when it is under load (i.e. your board is connected) that output will drop slightly. Which is why you're reading 5.29V. It should drop to just over 5V once you get it connected up.
Best Regards,
Julian (Fozzy The Bear)
-
Thanks fozzy, I hooked up the board, and it worked perfect, today I haven't did anything to the control part of the harness, so all that I could do was jut look at the screen, and listen to the music.
Hawk