Build Your Own Arcade Controls Forum

Main => Main Forum => Topic started by: madgammer on June 22, 2007, 08:01:48 pm

Title: Monitor burn in
Post by: madgammer on June 22, 2007, 08:01:48 pm

I just got a MK3 dedicated cab and noticed that it had a little burn in from the credits.  I was looking at it during the day and outside so it was a bit more obvious then outside or at night.  Is there any way to decrease the burn in or fix the monitor?  I don't think it would be too bad once it's in a darker room, but if it can be fixed or adjusted even better. 

Worse case scenerio how hard is it to replace the monitors on those cabs?

Title: Re: Monitor burn in
Post by: BobA on June 22, 2007, 09:02:51 pm

Put tinted plexi, tinted glass or sunshielded plexi over it and you will never see the burn.