Build Your Own Arcade Controls Forum
Main => Everything Else => Topic started by: Dervacumen on June 14, 2007, 02:11:59 pm
-
I always thought it would be fun to make a topiary so I settled on this one.
It will be a yellow flowering shrub yet to be determined. It's roughly two feet in circumference.
The construction began by using my duaghters play table as a circular template. I purchase some clothes line wire because it's green and bends fairly easy, yet holds it shape enough to give me some guides while trimming the plant to shape.
I taped the clothesline to the table to give me a rough outline of Pac-Man, then duplicated the design with a second piece to give me two matching sides. I tied some chicken wire to the top wireframe with some other thin wire I has laying about. The shrub will be trimmed about two inches away from the wire frame, so I made the Pac-Man mouth a little bigger than I would normally. Anyway, this is just a template so I can shape it as necessary once it gets growing.
So this is where I'm at right now.
The Pac-Man will be in a large pot, raised about 6 inches from the soil. I'm using a pot instead of planting in the ground so I can wheel the pot out near the street with a balloon attached when we have parties. I also want to take it with me if I move.
-
Not sure if you'll be able to find a yellow shrub that grows tightly bunched enough to make a topiary. And what do you need a guide for? Pac-Man is a circle with a wedge shape for a mouth. That only requires two cuts with a hedge trimmer and you're done.
-
I've identified two candidates already, just can't recall the names right now.
Pac-Man is a circle with a wedge shape for a mouth. That only requires two cuts with a hedge trimmer and you're done.
Not sure now that would do anything other than leave a big chunk out of the side of your plant exposing mostly bare branches inside. And the shape I'm going for is a disk rather than a ball.