Build Your Own Arcade Controls Forum
Main => Main Forum => Topic started by: dndcollect on May 31, 2007, 06:12:00 pm
-
Here is the problem, I just wired and basicly finished a bartop. I did not build it, I had some guy build it. (I am building my own from now on)
Anyway, it is brutal to pull apart and rewire. Anyway, it is a one player, wired and playable. I didnt realize that the esc key is wired to Player 2 start. I didnt wire player 2 start.
Is there a way around this? I dont want to have to take it aprt again, I might pass out from exaustion, lol.
I have tried going into the mame menu but it hasent worked.
Any ideas?
-
Player 2 start should be mapped to 2. If you press player 1 and player 2 at the same time it will send an escape command.
Everything you want can be found here:
http://www.ultimarc.com/ipac3.html (http://www.ultimarc.com/ipac3.html)
-
The problem is, my player 2 is not wired, so i dont have a player 2.
I must be blind but i dont see anything on the site about how to program it.
-
go into any mame game and press TAB on the keyboard go to general settings and scroll down to your problem highlight it and press the delete key on the key board if you want to re-assighn it to something else press enter and then press your key choice and it will input it now.
-
The problem is, my player 2 is not wired, so i dont have a player 2.
I must be blind but i dont see anything on the site about how to program it.
Well the page linked above, http://www.ultimarc.com/ipac3.html (http://www.ultimarc.com/ipac3.html)is headed "Programming"...
If you are still unsure, drop me an email and I will assist.
andy@ultimarc.com
-
i dont know how i missed that. wow.
im all set, thanks.