Build Your Own Arcade Controls Forum

Main => Main Forum => Topic started by: shawnzilla on April 18, 2003, 01:35:33 pm

Title: Attatching Glass to an Upright Cab?
Post by: shawnzilla on April 18, 2003, 01:35:33 pm

What is the best way to install the glass on a LUSID type cab? I would like to be able to remove it without too much trouble, should I need to adjust the monitor, etc...

Title: Re:Attatching Glass to an Upright Cab?
Post by: OSCAR on April 18, 2003, 01:44:40 pm

See this thread:  http://www.arcadecontrols.org/yabbse/index.php?board=1;action=display;threadid=4057;start=0.  This method may be a bit tricky to do with a LuSiD design because of the separte control panel, but it might give you some ideas.

In that thread is linked another thread which discussed this as well.

Title: Re:Attatching Glass to an Upright Cab?
Post by: Mike on April 18, 2003, 05:10:11 pm

I took the easy route, a glass drill bit and drilled a hole through each corner of the glass. then put screws through it into my bezel. I have these little black things that I got from the home depot that cover the screws. My bezel pulls right out so for me it's really easy to remove.

Title: Re:Attatching Glass to an Upright Cab?
Post by: shmokes on April 18, 2003, 05:15:02 pm

Pictures!!!  I'd like to see how you did this.

Title: Re:Attatching Glass to an Upright Cab?
Post by: SNAAAKE on April 19, 2003, 01:37:32 am

Quote from: shmokes on April 18, 2003, 05:15:02 pm

Pictures!!!  I'd like to see how you did this.

Well here is one if it helps... :)
I took the easy way around as well.
(http://www.imagestation.com/picture/sraid60/peb2e176e597eb65729ec8176c8ea3d2c/fc508f6f.jpg)
I got the idea from Scott's unicade.
http://home.austin.rr.com/shumate/unicade/