Build Your Own Arcade Controls Forum

Software Support => DOS/WinCab => Topic started by: Karaokedude on May 21, 2007, 08:44:11 am

Title: IPAC VE
Post by: Karaokedude on May 21, 2007, 08:44:11 am

has anyone tried the Ipac VE with Wincab
I have just recieved one the main reason for getting it was the small form factor PC i want to use only has USBs and no PS2 connections

i want to programme it for a numeric keypad

so I need to remap some keys to 0-9 the others arn't critical but the VE looses its programming on power down

Title: Re: IPAC VE
Post by: JustMichael on May 21, 2007, 01:33:59 pm

According to the documentation on the Ultimarc website:

Running from the command line.
You can run WinIPAC IPD from a command line giving an "invisible" way to download a specific keycode configuration to the I-PAC board. Just enter "WinIPAC nnn.IPC" where the correct IPC file is specified. This is how the Launcher program and MAMEWAH drives WinIPAC.

I would guess if you had a batch file that ran the programming utility then ran WinCab, you could do what you want.

Title: Re: IPAC VE
Post by: Chris on May 21, 2007, 03:13:40 pm

You can remap WinCab to anything as well, so if you can't get the VE mapped the way you want look in controls.ini to remap WinCab to match the VE.

--Chris