Build Your Own Arcade Controls Forum

Main => Main Forum => Topic started by: urbecrisch on April 15, 2007, 11:54:04 pm

Title: 2 Questions with pictures
Post by: urbecrisch on April 15, 2007, 11:54:04 pm

I'll get right to the nitty gritty.

1. What is this (PIC 1) and is it important to use?

2. How would I make this angle cut (PIC 2) on my CP?

Cheers!

Title: Re: 2 Questions with pictures
Post by: destructor on April 16, 2007, 01:07:34 am

1. Door switch. If door is open no power to PCB, or power is for test game mode. You can remove this and connect wires from this switch.

Title: Re: 2 Questions with pictures
Post by: NoOne=NBA= on April 16, 2007, 01:15:27 am

Quote from: urbecrisch on April 15, 2007, 11:54:04 pm

2. How would I make this angle cut (PIC 2) on my CP?

With the board stood on end on a table saw.
Set the rip fence 1/2" or so off the blade, and put the blade at the right angle.
You'll probably need to remove the blade guard to do it, so be careful.

Alternately, you could use a belt sander to do it.