Build Your Own Arcade Controls Forum

Main => Buy/Sell/Trade - non-retail => Topic started by: joeblade on April 11, 2007, 08:42:05 pm

Title: WTB: 27" Monitor Bezel (to fit a Curved WG9400) - Sydney, Australia
Post by: joeblade on April 11, 2007, 08:42:05 pm

Looking to buy a 27" Monitor Bezel, to sit in front of a WG9400 Curved CRT Monitor.

I am in Sydney, Australia - anyone know of any sources within Australia ? Or a source outside of Australia that could send one at a reasonable cost.

Tried getting onto Happs, but they don't seem to want to get back to me, and I assume (From reading other posts) that their shipping will be over the odds.

Alternatively, as a last resort, any good tutorials for make a decent looking bezel ? I have looked at the blurb under the "Monitors" section of the front page, but the "Big Dens Gameroom" link appears to be broken, and I wasn't too keen on the other instructions there.


Cheers

Title: Re: WTB: 27" Monitor Bezel (to fit a Curved WG9400) - Sydney, Australia
Post by: joeblade on April 11, 2007, 10:30:51 pm

Just found this thread - not sure why my original search didn't find it:

http://forum.arcadecontrols.com/index.php?topic=17175.0

If I can't source a plastic one cheaply, I will give this a go.